Toyota Venza: Components

Front Passenger Airbag Assembly

...

On-vehicle Inspection

ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to correctly follow the removal and installation procedures for the front passenger airbag assembly. PROCEDURE 1. INSPECT FRONT PA ...

Other materials about Toyota Venza:

Terminals Of Ecu
TERMINALS OF ECU 1. REAR TELEVISION CAMERA ASSEMBLY (a) Disconnect the R21 rear television camera assembly connector. (b) Measure the voltage on the wire harness side connector according to the value(s) in the table below. Terminal No. (Symb ...

Removal
REMOVAL PROCEDURE 1. REMOVE WINDSHIELD WIPER MOTOR AND LINK (a) Remove the windshield wiper motor and link (See page ). 2. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY 3. REMOVE COOL AIR INTAKE DUCT SEAL 4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY ...

Linear Solenoid Circuit (C1298/98)
DESCRIPTION The AWD control ECU receives signals from each sensor to control clutch pressure to distribute torque according to the driving conditions. DTC No. DTC Detection Condition Trouble Area C1298/98 ...