Toyota Venza: Voice is not Recognized

Toyota Venza Service Manual / Audio / Video / Audio And Visual System / Voice is not Recognized

PROCEDURE

1.	CHECK CONDITION

(a) Check if the system voice recognition level is low when recognizing a particular voice.

Result	Proceed to
System voice recognition level is low with any voice.	A
System voice recognition level is low only for a particular voice.	B

HINT:

System voice recognition level varies depending on voice and pronunciation. This is not a malfunction.

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

END

Voice Guidance does not Function

PROCEDURE 1. CHECK VOICE GUIDANCE SETTING (a) Check that the voice guidance setting is not off. OK: Voice guidance setting is not off. NG CHANG ...

Cellular Phone Registration Failure

PROCEDURE 1. CHECK USAGE CONDITION (a) Check that the vehicle and cellular phone meet the following conditions: NOTICE: If changing cellular phone settings, updatin ...

Other materials about Toyota Venza:

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK ENGINE SWITCH (a) Disconnect the D13 engine switch connector. (b) Measure the resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with connector disconnected. T ...

Positioning a floor jack
When raising your vehicle with a floor jack, position the jack correctly. Improper placement may damage your vehicle or cause injury. ►Front ►Rear (2WD models) ►Rear (AWD models) CAUTION - When raising your vehicle Make sur ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes. (e) Check for DTCs. 2. CLEAR DTC ( ...