Toyota Venza: Voice Guidance does not Function

Toyota Venza Service Manual / Audio / Video / Audio And Visual System / Voice Guidance does not Function

PROCEDURE

1.	CHECK VOICE GUIDANCE SETTING

(a) Check that the voice guidance setting is not off.

OK:

Voice guidance setting is not off.

CHANGE THE VOICE GUIDANCE SETTING TO ON

2.	CHECK AUDIO FUNCTION

(a) Check that sound can be heard from a front speaker.

OK:

Sound can be heard.

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Poor Sound Quality in All Modes (Low Volume)

PROCEDURE 1. CHECK AUDIO SETTINGS (a) Set treble, middle and bass to the initial values and check that the sound is normal. OK: The sound returns to normal. HIN ...

Voice is not Recognized

PROCEDURE 1. CHECK CONDITION (a) Check if the system voice recognition level is low when recognizing a particular voice. Result Proceed to ...

Other materials about Toyota Venza:

Clearance Sonar Main Switch Circuit
DESCRIPTION The back sonar or clearance sonar switch assembly is installed at the base of the driver side of the instrument panel. When the clearance sonar main switch is turned on, an on signal is sent to the clearance warning ECU assembly. The intuitiv ...

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock control system is operating normally. Check the power door lock control system first before troub ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH side and RH side. The following procedure is for the LH side. PROCEDURE 1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE (for 2GR-FE) HINT: Refer to the procedure up to Re ...