Toyota Venza: Traffic Information is not Displayed

Toyota Venza Service Manual / Navigation / Multi Info Display / Navigation System / Traffic Information is not Displayed

PROCEDURE

1.	CHECK DISPLAY

(a) Check which communication is not being used for displaying traffic information.

HINT:

Display of traffic information received via HD traffic is given priority while in an "HD Radio" service area.

OK:

Traffic information using "HD Radio" communication is not displayed.

2.	CHECK SYMPTOMS

(a) Check for symptoms (poor sound quality, sounds cannot be heard, etc.) during conventional FM radio broadcasting.

Result	Proceed to
Symptoms do not occur.	A
Symptoms occur.	B

GO TO "RADIO BROADCAST CANNOT BE RECEIVED OR POOR RECEPTION" IN PROBLEM SYMPTOMS TABLE

3.	CHECK SETTINGS OF TRAFFIC INFORMATION

(a) Check if the display setting of traffic information on the navigation screen is on.

OK:

The display setting of traffic information is on.

END

4.	CHECK SCALE OF MAP DISPLAY

(a) Check if the traffic information that is currently not displayed can be displayed at the scale shown in the table below.

Traffic Information to be Displayed	Display Scale
Traffic information list.	1:1280000 or below
Traffic information icon (Closed Road, Accidents, Danger, Road Conditions, Road Works, Weather).	1:640000 or below
Traffic information icon (Stationary Traffic Jam, Delays, Parking, Other)	1:80000 or below

OK:

Traffic information can be displayed.

END

REPLACE NAVIGATION RECEIVER ASSEMBLY

Noise Occurs

PROCEDURE 1. CHECK NOISE CONDITION (a) Check from which direction the noise comes (front left or right, or rear left or right). OK: The location of the noise sou ...

No Sound can be Heard from Speakers

PROCEDURE 1. CHECK AUDIO SETTINGS (a) In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal. OK: A ...

Other materials about Toyota Venza:

Control Module Performance (P0607)
MONITOR DESCRIPTION The ECM continuously monitors its internal processors (CPUs) and heated oxygen sensor transistors. This self-check ensures that the ECM is functioning properly. DTC No. DTC Detection Condition Trouble Ar ...

Cold Start Ignition Timing Performance (P050B)
DESCRIPTION This monitor will run when the engine is started at an engine coolant temperature of -10 to 50°C (14 to 122°F). The DTC is stored after the engine idles for 13 seconds (2 trip detection logic). The DTC is designed to monitor the ignition ti ...

Oxygen (A/F) Sensor Signal Stuck Lean (Bank 1 Sensor 1) (P2195,P2196)
DESCRIPTION HINT: Although the DTC titles say oxygen sensor, these DTCs relate to the air fuel ratio sensor. Sensor 1 refers to the sensor mounted in front of the three-way catalytic converter and located near the engine assembly. ...