Toyota Venza: Towing with a sling-type truck

Before towing

The following may indicate a problem with your transmission. Contact your Toyota dealer before towing. • The engine is running, but the vehicle will not move. • The vehicle makes an abnormal s ...

Towing with a wheel lift-type truck

►From the front (2WD models) Release the parking brake. ►From the front (AWD models) Use a towing dolly under the rear wheels. ► From the rear Use a towing dolly under the ...

Other materials about Toyota Venza:

Vehicle Lift And Support Locations
VEHICLE LIFT AND SUPPORT LOCATIONS 1. NOTICE ABOUT VEHICLE CONDITION WHEN RAISING VEHICLE (a) The vehicle must be unloaded before jacking up or raising the vehicle. Never jack up or raise a heavily loaded vehicle. (b) When removing any heavy components li ...

Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0141,P102D)
DESCRIPTION Refer to DTC P0136 (See page ). HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is t ...

Electrical Key Oscillator(for Rear Side)
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE REAR BUMPER PLATE LH 2. REMOVE REAR BUMPER PLATE RH 3. REMOVE REAR BUMPER ASSEMBLY 4. REMOVE ELECTRICAL KEY ANTENNA (a) Disconnect the connector. ...