Toyota Venza: Taking out the spare tire

Taking out the jack

Remove the left side deck board. Unlock the tightening strap. After storing the jack, make sure it is securely held by the tightening strap. ...

Replacing a flat tire

Chock the tires. Slightly loosen the wheel nuts (one turn). Turn the tire jack portion “A” by hand until the notch of the jack is in contact with the jack point. Raise the vehicle u ...

Other materials about Toyota Venza:

Microphone
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE INNER REAR VIEW MIRROR STAY HOLDER COVER 2. REMOVE TELEPHONE MICROPHONE ASSEMBLY (INNER REAR VIEW MIRROR ASSEMBLY) Installation INSTALLATION PROCEDURE 1. INSTALL TE ...

Intermediate Shaft Speed Sensor "A" Circuit (P0791,P0793)
DESCRIPTION This sensor detects the rotation speed of the counter gear which shows the output speed of transaxle. By comparing the input turbine speed signal (NT) with the counter gear speed sensor signal (NC), the TCM detects the shift timing of the gear ...

Torque Converter Clutch Pressure Control Solenoid Control Circuit Electrical (Shift Solenoid Valve SLU) (P2759)
DESCRIPTION The amount of current flow to the solenoid is controlled by the duty ratio of the TCM output signal. The higher the duty ratio becomes, the higher the lock-up hydraulic pressure becomes during the lock-up operation. DTC No. ...