Toyota Venza: Sunshade

Moon roof

Use the overhead switches to open, close, and tilt the moon roof up and down.  - Opening and closing 1. Open The moon roof stops slightly before the fully open position to reduce wind noise. ...

Refueling

...

Other materials about Toyota Venza:

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) (a) Disconnect the P4 ECU connector. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure the values on the wire harness si ...

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater Syste ...

Installation
INSTALLATION PROCEDURE 1. TEMPORARILY INSTALL SLIDING ROOF HOUSING ASSEMBLY (a) Temporarily install the sliding roof housing panel with the 18 nuts. NOTICE: When installing the housing to the vehicle, first install the housing center front and ...