Toyota Venza: Registration

Toyota Venza Service Manual / 1ar-fe Engine Control / Sfi System / Registration

REGISTRATION

CAUTION / NOTICE / HINT

NOTICE:

The Vehicle Identification Number (VIN) must be input into the replacement ECM.

HINT:

The VIN is a 17-digit alphanumeric vehicle identification number. The Techstream is required to register the VIN.

PROCEDURE

1. DESCRIPTION

HINT:

This registration section consists of 2 parts: Read VIN and Write VIN.

(a) Read VIN: This process allows the VIN stored in the ECM to be read in order to confirm that the 2 VINs, the one provided with the vehicle and stored in the vehicle ECM, are the same.

(b) Write VIN: This process allows the VIN to be input into the ECM. If the ECM is changed, or the ECM VIN and vehicle VIN do not match, the VIN can be registered, or overwritten in the ECM by following this procedure.

2. READ VIN

(a) Confirm the vehicle VIN.

(b) Connect the Techstream to the DLC3.

(d) Turn the Techstream on.

(e) Enter the following menus: Powertrain / Engine / Utility / VIN / VIN Read.

3. WRITE VIN

(a) Confirm the vehicle VIN.

(b) Connect the Techstream to the DLC3.

(d) Turn the Techstream on.

(e) Enter the following menus: Powertrain / Engine / Utility / VIN / VIN Write.

Check For Intermittent Problems

CHECK FOR INTERMITTENT PROBLEMS HINT: Inspect the ECM using check mode. Intermittent problems are easier to detect with the Techstream when the ECM is in check mode. In check mode, the ECM uses 1 ...

Checking Monitor Status

CHECKING MONITOR STATUS The purpose of the monitor result (mode 06) is to allow access to the results of on-board diagnostic monitoring tests of specific components/systems that are not continuou ...

Other materials about Toyota Venza:

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful bec ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE PROPELLER SHAFT (a) Place matchmarks on both flanges. Text in Illustration *1 Matchmark (b) Remove the 4 nuts, ...

System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line ECM Navigation Receiver Assembly*1 Radio and Display Receiver Assembly*2 Reverse sig ...