Toyota Venza manuals

Toyota Venza: Precaution

PRECAUTION

NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

System Name

See Procedure

Power back door system


Back door closer system

1. EXPRESSIONS OF IGNITION SWITCH

The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression

Switch Type

Ignition Switch (Position)

Engine Switch (Condition)

Ignition Switch off

LOCK

Off

Ignition Switch ON

ON

On (IG)

Ignition Switch ACC

ACC

On (ACC)

Engine Start

START

Start

Parts Location
PARTS LOCATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

System Diagram
SYSTEM DIAGRAM 1. CAN SIGNAL 2. DIRECT LINE SIGNAL (a) Combination Meter Assembly (b) Accessory Meter Assembly 3. INPUT AND OUTPUT SIGNALS OF THE COMBINATION METER ASSEMBLY OR ACCESSORY MET ...

Other materials about Toyota Venza:

Open in Stop Light Switch Circuit (C1249/49)
DESCRIPTION The skid control ECU (housed in the actuator assembly) inputs the stop light switch signal and the condition of brake operation. The skid control ECU has an open detection circuit, which outputs this DTC when detecting an open in the stop lig ...

Removal
REMOVAL PROCEDURE 1. REMOVE WINDSHIELD WIPER MOTOR AND LINK (a) Remove the windshield wiper motor and link (See page ). 2. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY 3. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY 4. REMOVE COOL AIR INTAKE DUCT SEAL ...

Starter Relay Circuit High (P0617)
DESCRIPTION While the engine is being cranked, battery voltage is applied to terminal STA of the TCM. If the TCM detects the Starter Control (STA) signal while the vehicle is being driven, it determines that there is a malfunction in the STA circuit. The ...

© 2016-2026 Copyright www.tovenza.com

0.1423