Toyota Venza manuals

Toyota Venza: Precaution

PRECAUTION

NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

System Name

See Procedure

Back Door Closer System


Power Back Door System

Parts Location
PARTS LOCATION ILLUSTRATION ILLUSTRATION ...

System Description
SYSTEM DESCRIPTION 1. GENERAL The rear window defogger wires are attached to the inside of the rear window and defog the window surface quickly by pressing the rear window defogger switch on the ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY NOTICE: Do not replace the spiral cable with the battery connected and the ignition switch on (IG). Do not rotate the spiral cable with the battery connected and the ig ...

Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0141,P102D)
DESCRIPTION Refer to DTC P0136 (See page ). HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is t ...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT COOLING FAN OPERATION AT LOW TEMPERATURES (Below 83°C (181°F)) (a) Turn the ignition switch to ON. (b) Check that the cooling fans stop. If not, check the cooling fan relays and engine coolant temperature senso ...

© 2016-2026 Copyright www.tovenza.com

0.1298