Toyota Venza: Precaution

Toyota Venza Service Manual / Window / Glass / Power Window Control System / Precaution

PRECAUTION

1. EXPRESSIONS OF IGNITION SWITCH

(a) The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

Switch Type		Ignition Switch (Position)	Engine Switch (Condition)
Expression	Ignition switch off	LOCK	Off
	Ignition switch ON	ON	On (IG)
	Ignition switch ACC	ACC	On (ACC)
	Engine Start	START	Start

2. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected:

System Name	See Procedure
Back Door Closer System
Power Back Door System

3. POWER WINDOW CONTROL SYSTEM PRECAUTIONS

CAUTION:

The power window control system prohibits the auto up/down function when the jam protection function malfunctions. Therefore, troubleshoot the power window control system after confirming that no trouble codes are output.
When a power window regulator or a power window regulator motor assembly is replaced, the power window control system must be initialized.
After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be reinitialized by repeating the following operation at least 5 times:
1. Close the power window by fully pulling up the power window regulator master switch assembly or power window regulator switch assembly and holding it at the auto up position.
2. Open the power window by fully pushing down the power window regulator master switch assembly or power window regulator switch assembly.
The jam protection function may operate unexpectedly even when the power window control system is normal due to detection of a value different from the operation learned value when the door glass moving speed changes sharply under any of the following conditions:
1. A power window is being opened or closed while the vehicle is driven on a rough road.
2. A power window is being opened or closed while the door is being opened or closed.
3. The voltage changes abruptly.

NOTICE:

Do not disconnect the battery while the ignition switch is ON. Otherwise, DTC B2311 will be output.

Parts Location

PARTS LOCATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Malfunction in Deceleration Sensor (C0365/28,C1234/34,C1245/32,C1245/45)
DESCRIPTION The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system. The yaw rate sensor has a built-in acceleration sensor. If there is trouble in the bus lines between the yaw rate and acceleratio ...

Vehicle Speed or Engine Speed Signal Malfunction (C2173/73)
DESCRIPTION The tire pressure warning ECU receives a vehicle speed signal from the combination meter and an engine speed signal from the ECM. The tire pressure warning ECU uses these signals to detect DTCs C2121/21 to C2124/24 (No Signal from Transmitter) ...

Air Conditioning Amplifier Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Air Conditioning Amplifier Communication Stop Mode "Air Conditioner" is not displayed on "CAN Bus Check" screen o ...