Toyota Venza: Power Window Regulator Motor(for Rear Door)

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL FRONT POWER WI ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Antenna Coil Open / Short (B2784)
DESCRIPTION The transponder key coil is built into the transponder key amplifier and receives a key code signal from the transponder chip in the key. This signal is amplified by the amplifier, then it is output to the transponder key ECU assembly. ...

Removal
REMOVAL PROCEDURE 1. REMOVE WINDSHIELD WIPER MOTOR AND LINK (a) Remove the windshield wiper motor and link (See page ). 2. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY 3. REMOVE COOL AIR INTAKE DUCT SEAL 4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL MAGNETIC CLUTCH ASSEMBLY (a) Install the magnetic clutch stator while aligning the protrusion on the stator with the notch on the air compressor assembly as shown in the illustration. ...