Toyota Venza: Front Airbag Sensor RH Malfunction (B1610/13)

Toyota Venza Service Manual / Supplemental Restraint Systems / Airbag System / Front Airbag Sensor RH Malfunction (B1610/13)

DESCRIPTION

The front airbag sensor RH circuit consists of the center airbag sensor assembly and front airbag sensor RH.

The front airbag sensor RH detects impacts to the vehicle and sends signals to the center airbag sensor assembly to determine if the airbag should be deployed.

DTC B1610/13 is stored when a malfunction is detected in the front airbag sensor RH.

DTC No.	DTC Detection Condition	Trouble Area
B1610/13	Front airbag sensor RH malfunction Center airbag sensor assembly malfunction	Front airbag sensor RH Center airbag sensor assembly

WIRING DIAGRAM

PROCEDURE

1.	CHECK FRONT AIRBAG SENSOR RH

(a) Turn the ignition switch off.

(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

(d) Connect the cable to the negative (-) battery terminal.

(e) Turn the ignition switch to ON, and wait for at least 60 seconds.

(f) Clear the DTCs stored in memory (See page ).

(g) Turn the ignition switch off.

(h) Turn the ignition switch to ON, and wait for at least 60 seconds.

(i) Check for DTCs (See page ).

Result	Proceed to
DTCs B1610/13 and B1615/14 are not output.	A
DTC B1610/13 is output.	B
DTC B1615/14 is output.	C

Text in Illustration

*1	Front Airbag Sensor LH
*2	Center Airbag Sensor Assembly

HINT:

Codes other than DTCs B1610/13 and B1615/14 may be output at this time, but they are not related to this check.

USE SIMULATION METHOD TO CHECK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY

REPLACE FRONT AIRBAG SENSOR RH

Lost Communication with Front Airbag Sensor RH (B1612/83,B1613/83)

DESCRIPTION The front airbag sensor RH circuit consists of the center airbag sensor assembly and front airbag sensor RH. The front airbag sensor RH detects impacts to the vehicle and sends signals ...

SRS Warning Light Remains ON

DESCRIPTION The SRS warning light is located on the combination meter assembly. When the SRS is normal, the SRS warning light comes on for approximately 6 seconds after the ignition switch is turn ...

Other materials about Toyota Venza:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CHECK BATTERY CONDITION NOTICE: If the battery is weak or if the engine is difficult to start, perform the following procedure. (a) Check the battery for damage and deformation. If severe damage, deformation or leaka ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 2 STEERING RACK BOOT (a) Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot. (b) Install the No. 2 ste ...

Inspection
INSPECTION PROCEDURE 1. INSPECT GENERATOR CLUTCH PULLEY (a) Hold the generator rotor using SST, and turn the clutch pulley clockwise to check that the outer ring locks. SST: 09820-63021 Text in Illustration *1 ...