Toyota Venza manuals

Toyota Venza: Power outlets

The power outlets can be used for 12V accessories that run on less than 10A.

►Console box


►Front passenger’s side instrument panel


►Luggage compartment


 - The power outlets can be used when

►Vehicles with smart key system The “ENGINE START STOP” switch is in ACCESSORY or IGNITION ON mode.

►Vehicles without smart key system The engine switch is in the “ACC” or “ON” position.

NOTICE
 - To avoid damaging the power outlets

Close the power outlet lid when not in use.

Foreign objects or liquids that enter the power outlet may cause a short circuit.

- To prevent the fuse from being blown


Do not use an accessory that uses more than 12 V/10 A.

- To prevent the battery from being discharged

Do not use the power outlet longer than necessary when the engine is not running.

Vanity mirror
Slide the cover. The light turns on when the cover is opened. ...

Seat heaters
1. For driver’s seat 2. For front passenger’s seat 3. On The indicator light comes on. 4. Adjusts the seat temperature The further you turn the dial upward, the warmer the seat becomes. &n ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 3. REMOVE FRONT WHEE ...

TC and CG Terminal Circuit
DESCRIPTION Connecting terminals TC and CG of the DLC3 causes the AWD control ECU to display 2-digit DTCs by flashing the AWD warning light. HINT: When each warning light remains blinking, a short to ground in the wiring of terminal TC of the DLC3 or an ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE REAR WHEEL 2. REMOVE DECK SIDE TRIM (a) Disengage the 5 claws, and ...

© 2016-2026 Copyright www.tovenza.com

0.1569