Toyota Venza manuals

Toyota Venza: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION

(a) Apply the parking brake.

(b) Turn the ignition switch to ON.

(c) Depress the brake pedal and check that the engine starts when the shift lever is in N or P, but does not start in any other position.

(d) Check that the back-up light comes on when the shift lever is moved to R, but the light does not operate in any other position. If the operation cannot be done as specified, check the park/neutral position switch for continuity.

Components
COMPONENTS ILLUSTRATION ...

Removal
REMOVAL PROCEDURE 1. REMOVE COOL AIR INTAKE DUCT SEAL 2. REMOVE INLET NO. 2 AIR CLEANER 3. REMOVE AIR CLEANER CAP WITH HOSE 4. REMOVE AIR CLEANER CASE 5. REMOVE AIR CLEANER BRACKET ...

Other materials about Toyota Venza:

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column ...

Installation
INSTALLATION PROCEDURE 1. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER (a) Using a tacker, install the separate type front seat cushion heater to the end of the separate type front seat cushion cover with 25 new tack pins. NOTICE: ...

Knock Sensor
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE INTAKE MANIFOLD (a) Remove the intake manifold (See page ). 2. REMOVE KNOCK SENSOR (a) Disconnect the sensor connector. ...

© 2016-2026 Copyright www.tovenza.com

0.1418