Toyota Venza: Lost Communication with ECM (U0101,U0073,U0126,U0129,U0142,U0182,U1000)

Toyota Venza Service Manual / Lighting (ext) / Lighting System / Lost Communication with ECM (U0101,U0073,U0126,U0129,U0142,U0182,U1000)

DESCRIPTION

The DTCs are stored when the CAN communication system is malfunctioning.

DTC No.	DTC Detection Condition	Trouble Area
U0101	Lost communication with ECM	CAN communication system
U0073	Control module communication bus off	CAN communication system
U0126	Lost communication with steering angle sensor	CAN communication system
U0129	Lost communication with skid control ECU	CAN communication system
U0142	Lost communication with main body ECU (driver side junction block assembly)	CAN communication system
U0182	Lost communication with AFS ECU (headlight swivel ECU assembly)	CAN communication system
U1000	Can communication failure (message registry)	CAN communication system

PROCEDURE

1.	CHECK FOR DTC

(a) Clear the DTCs (See page ).

(b) Check for DTCs (See page ).

OK:

DTCs are not output.

USE SIMULATION METHOD TO CHECK

GO TO CAN COMMUNICATION SYSTEM

Light Sensor Circuit Malfunction (B1244)

DESCRIPTION The automatic light control sensor detects ambient light, converts it into an electrical signal, and outputs it to the main body ECU (driver side junction block assembly). The main bo ...

Automatic High Beam Mirror (B124A)

DESCRIPTION The DTC is stored when the main body ECU (driver side junction block assembly) detects malfunctions in the inner rear view mirror assembly. DTC No. DTC Detection ...

Other materials about Toyota Venza:

Wireless Door Lock Buzzer
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL WIRELESS DOOR LOCK BUZZER (a) Engage the clamp and install the wireless door lock buzzer. (b) Connect the ...

Precaution
PRECAUTION NOTICE: When the ignition switch is turned off and the engine temperature is high, the cooling fans may operate for a maximum of 6 minutes. After turning the ignition switch off, keep hands and objects away from the fans when t ...

Transmitter ID1 Operation Stop (C2111/11-C2114/14)
DESCRIPTION The tire pressure warning valve and transmitter installed in each tire and wheel assembly measures the tire pressures. The measured values are transmitted as radio waves to the tire pressure warning antenna and receiver on the body and then se ...