Toyota Venza: Installation

Toyota Venza Service Manual / Axle And Differential / Rear Axle Hub(for 2wd) / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

(a) Install the parking brake assembly and the rear axle hub and bearing assembly with the 4 bolts.

Torque:

80 N·m {816 kgf·cm, 59 ft·lbf}

NOTICE:

Do not twist the No. 3 parking brake cable assembly when installing it.

2. INSPECT REAR AXLE HUB BEARING LOOSENESS

3. INSPECT REAR AXLE HUB RUNOUT

4. INSTALL REAR SPEED SENSOR WIRE

5. INSTALL REAR DISC

6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

7. INSTALL REAR FLEXIBLE HOSE

8. INSTALL REAR WHEEL

Torque:

103 N·m {1050 kgf·cm, 76 ft·lbf}

9. CHECK FOR SPEED SENSOR SIGNAL

(a) Check for the speed sensor signal (See page ).

Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE REAR WHEEL 2. SEPAR ...

Other materials about Toyota Venza:

Front Passenger Side Door ECU Communication Stop (B2322)
DESCRIPTION This DTC is stored when LIN communication between the power window regulator motor assembly (for front passenger side) and main body ECU (driver side junction block assembly) stops for more than 10 seconds. DTC No. DTC D ...

Window Glass Antenna Wire
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT WINDOW GLASS ANTENNA WIRE (a) Check for continuity of the antenna. HINT: Check for continuity at the center of each antenna wire as shown in the illustration. N ...

Terminals Of Ecu
TERMINALS OF ECU 1. COMBINATION METER ASSEMBLY (a) Measure the voltage and resistance according to the value(s) in the table below. Terminal No. (Symbol) Wiring Color Terminal Description Condition ...

Toyota Venza: Installation

Removal

Rear Axle Hub(for Awd)

Other materials about Toyota Venza: