Toyota Venza: Front Seat Side Airbag Assembly

Disposal

DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS component, review and closely follow all applicable environmental and hazardous material regulations ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP (w/o Sliding Roof) NOTICE: If reusing the clips, do not remove the double-sided tape remaining on the clips and where the clips will be installed on the body. If installi ...

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR BUMPER ASSEMBLY (a) w/ Intuitive Parking Assist System: (1) Connect each connector. (b) Engage the 6 claws and install the rear bumper assembly as shown in the illustration. ...

Short in Front Passenger Side Squib Circuit (B1805/52-B1808/52)
DESCRIPTION The front passenger side squib circuit consists of the center airbag sensor assembly and front passenger airbag assembly. The center airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These DTCs ...