Toyota Venza manuals

Toyota Venza: Dtc Check / Clear

DTC CHECK / CLEAR

1. CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Driver Seat / Trouble Codes.

(e) Check for DTCs (See page ).


2. CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Driver Seat / Trouble Codes.

(e) Clear the DTCs.

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK POSITION CONTROL ECU AND SWITCH ASSEMBLY (a) Disconnect the T10 and T11 position control ECU and switch assembly connectors. (b) Measure the voltage and resistance accor ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Other materials about Toyota Venza:

Security Indicator Light Circuit
DESCRIPTION Even when the theft deterrent system is in the disarmed state, the security indicator blinks due to a signal output from the immobiliser system. The security indicator blinks continuously due to a continuous signal received from the immobilise ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" ...

Brake Warning Light does not Come ON
DESCRIPTION The skid control ECU is connected to the combination meter via CAN communication. WIRING DIAGRAM Refer to Brake Warning Light Remains ON (See page ). PROCEDURE 1. CHECK CAN COMMUNICATION SYSTEM (a) Check if a ...

© 2016-2026 Copyright www.tovenza.com

0.1241