Toyota Venza manuals

Toyota Venza: Dtc Check / Clear

DTC CHECK / CLEAR

1. CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Read the DTC by following the prompts on the Techstream screen.

HINT:

Refer to the Techstream operator's manual for further details.

2. CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Clear the DTC by following the directions on the Techstream screen.

HINT:

Refer to the Techstream operator's manual for further details.

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION The ECU stores trouble codes when malfunctions occur. The diagnostic system allows for reading of the trouble codes from the DLC3. Use the Techstream to help diagno ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR DRIVE SHAFT ASSEMBLY (a) Align the shaft splines and install the rear drive shaft assembly using a screwdriver and hammer. NOTICE: Set the snap ring with the opening facing downward. ...

Removal
REMOVAL PROCEDURE 1. REMOVE FRONT DOOR SCUFF PLATE LH (a) Disengage the 3 clips, 7 claws and guide, and remove the front door scuff plate LH. 2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH ...

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) Data of the system can be read from the Data Link Connector 3 (DLC3) of the vehicle. Therefore, when the system seems to be malfunctioning, use the Techstream to check for a malfunction and repair it. 2. CHECK DLC3 ( ...

© 2016-2026 Copyright www.tovenza.com

0.1324