Toyota Venza: Drive Shaft System
Precaution
PRECAUTION
1. NOTICE OF REMOVING AND INSTALLING FRONT DRIVE SHAFT ASSEMBLY RH
(a) When removing and installing the front drive shaft assembly RH in a AWD vehicle, be sure to first drain all the transaxle oil and transfer oil. If removal and installation are carried out without draining these oils, the transfer oil will flow into the transaxle side. Extensive cleaning will be required if the two oils mix.
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of the problem symptoms. If multiple suspected areas are listed, the potential causes of symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Drive Shaft System|
Symptom |
Suspected Area |
See page |
|---|---|---|
|
Front wheel shimmy |
Front drive shaft (worn) |
|
|
Rear wheel shimmy (for AWD) |
Rear drive shaft (worn) |
|
.gif)
Other materials about Toyota Venza:
Vehicle load limits
Vehicle load limits include total load capacity, seating capacity, Trailer
Weight Rating (TWR) and cargo capacity.
- Total load capacity (Vehicle capacity weight):
Total load capacity means the combined weight of occupants, cargo and luggage.
&nbs ...
Initialization
INITIALIZATION
HINT:
In vehicles equipped with the push-button start function, the starting function
may not be operational after recharging or while jump-starting a discharged battery.
This condition is most likely to occur if battery voltage drops belo ...
TC and CG Terminal Circuit
DESCRIPTION
DTC output mode is set by connecting terminals TC and CG of the DLC3.
DTCs are displayed by blinking of the SRS warning light.
HINT:
When each warning light stays blinking, a ground short in the wiring
of terminal TC of the DLC3 or ...
0.1525