Toyota Venza manuals

Toyota Venza: Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY


2. REMOVE PARKING BRAKE SWITCH ASSEMBLY


3. REMOVE PARKING PEDAL PAD

(a) Remove the parking pedal pad from the parking brake pedal assembly.

Removal
REMOVAL PROCEDURE 1. REMOVE YAW RATE AND ACCELERATION SENSOR HINT: Refer to the instructions for Removal of the yaw rate and acceleration sensor (See page ). 2. REMOVE REAR NO. 2 AIR DUCT ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL PARKING PEDAL PAD (a) Install the parking pedal pad to the parking brake pedal assembly. 2. INSTALL PARKING BRAKE SWITCH ASSEMBLY 3. INSTALL NO. 1 PARKING BRAKE ...

Other materials about Toyota Venza:

Front Airbag Sensor RH Malfunction (B1610/13)
DESCRIPTION The front airbag sensor RH circuit consists of the center airbag sensor assembly and front airbag sensor RH. The front airbag sensor RH detects impacts to the vehicle and sends signals to the center airbag sensor assembly to determine if the ...

Front Speed Sensor RH Circuit (C0200/31,C0205/32,C1271/71,C1272/72,C1330/35,C1331/36)
DESCRIPTION The speed sensor detects wheel speed and sends the appropriate signals to the skid control ECU. These signals are used for the ABS control system. Speed sensor rotors have 48 serrations. The hall IC type speed sensor use the frequency of outp ...

Uniform Tire Quality Grading
This information has been prepared in accordance with regulations issued by the National Highway Traffic Safety Administration of the U.S. Department of Transportation. It provides the purchasers and/or prospective purchasers of Toyota vehicles with infor ...

© 2016-2026 Copyright www.tovenza.com

0.1757