Toyota Venza manuals

Toyota Venza: Diagnosis System

DIAGNOSIS SYSTEM

1. CHECK DLC3

(a) Check the DLC3 (See page ).


2. INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery.

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK COMBINATION METER ASSEMBLY (a) Measure the resistance and voltage according to the value(s) in the table below. Tester Connection Wiring Color ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE (a) Remove the fuel suction tube assembly with pump and gauge (See page ). 2. REMOVE FUEL SENDER GAUGE 3. REMOVE FUEL FILTER ASSEMBLY (a) Disconnect the fuel pump ...

Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A) (P0016,P0017)
DESCRIPTION In the VVT (Variable Valve Timing) system, the appropriate intake and exhaust valve open and close timing is controlled by the ECM. The ECM performs intake and exhaust valve control by performing the following: 1) controlling the camshaft and ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful bec ...

© 2016-2026 Copyright www.tovenza.com

0.1508