Toyota Venza manuals

Toyota Venza: Diagnosis System

DIAGNOSIS SYSTEM

1. DESCRIPTION

(a) The power window control system data can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs.

2. CHECK DLC3

(a) Check the DLC3 (See page ).


3. INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery.

Terminals Of Ecu
TERMINALS OF ECU 1. POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (a) Disconnect the I6 power window regulator master switch assembly connector. (b) Measure the voltage and resistance according t ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / (desired sy ...

Other materials about Toyota Venza:

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptom are listed in order of probability in the "Suspected Area" ...

ECM Power Source Circuit
DESCRIPTION When the ignition switch is turned to ON, the battery voltage is applied to IGSW of the ECM. The output signal from the MREL terminal of the ECM causes a current to flow to the coil, closing the contact of the engine room junction block assemb ...

Fail-safe Chart
FAIL-SAFE CHART 1. Fail-safe This function minimizes the loss of operation when any abnormality occurs in a sensor or solenoid. Fail-safe Control List Malfunction Part Function Input Turbine Speed Sensor ...

© 2016-2026 Copyright www.tovenza.com

0.1521