Toyota Venza manuals

Toyota Venza: Diagnosis Circuit

DESCRIPTION

The headlight leveling ECU assembly outputs DTC information to the Techstream via this circuit.

WIRING DIAGRAM


PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (DLC3 - HEADLIGHT LEVELING ECU ASSEMBLY)

(a) Disconnect the A40 headlight leveling ECU assembly connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

A40-15 (PRST) - D1-7 (SIL)

Always

Below 1 Ω

A40-15 (PRST) - Body ground

Always

10 kΩ or higher


OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE


NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

LVL Terminal Circuit
DESCRIPTION By connecting terminals LVL and CG of the DLC3, the headlight leveling ECU assembly initializes the height control sensor signal. WIRING DIAGRAM PROCEDURE ...

Rear Combination Light Assembly
...

Other materials about Toyota Venza:

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (CHECK USING TECHSTREAM) (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes. (e) Chec ...

Ultrasonic Sensor(for Front Side)
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY (See page ) 2. REMOVE NO. 1 ULTRASONIC SENSOR (a) Disengage the 2 claws to remove the No. 1 ultrasonic sensor. HINT: Use the same proc ...

Do-it-yourself service precautions
If you perform maintenance yourself, be sure to follow the correct procedure given in these sections. CAUTION The engine compartment contains many mechanisms and fluids that may move suddenly, become hot, or become electrically energized. To avoid de ...

© 2016-2026 Copyright www.tovenza.com

0.1278