CUSTOMIZE PARAMETERS
1. CUSTOMIZING FUNCTION WITH TECHSTREAM
HINT:
The following items can be customized.
NOTICE:
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Customize Setting / Illuminated Entry.
(e) Select the setting by referring to the table below.
Illuminated Entry|
Tester Display |
Default |
Contents |
Setting |
|---|---|---|---|
|
Lighting Time |
15 s |
Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the ignition switch from off to ACC or ON.) |
15 s, 7.5 s or 30 s |
|
I/L when ACC OFF |
ON |
Lights up the transponder key amplifier*1, roof console box assembly, step or spot light assembly and engine switch illumination*2 when the ignition switch is turned from ACC or ON to off. |
ON or OFF |
|
I/L ON W/Door Key Unlock |
ON |
Lights up the transponder key amplifier*1, roof console box assembly, step or spot light assembly and engine switch illumination*2 when doors are unlocked using a mechanical key or door control transmitter. |
ON or OFF |
|
Room Light when Aprchd*2 |
ON |
Lights up the roof console box assembly, step or spot light assembly and engine switch illumination when the key enters any actuation area around the doors. |
ON or OFF |
|
Interior Light Control |
ON |
Lights up the transponder key amplifier*1, roof console box assembly, step or spot light assembly and engine switch illumination*2 when the illuminated entry function is operating. |
ON or OFF |
HINT:
System Description
Operation CheckInstallation
INSTALLATION
PROCEDURE
1. INSTALL PARKING BRAKE PEDAL ASSEMBLY
(a) Install the parking brake pedal assembly with the 3 nuts.
Torque:
21 N·m {214 kgf·cm, 15 ft·lbf}
(b) Connect t ...
Clearance Warning Buzzer
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT DOOR SCUFF PLATE LH
2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
3. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
4. REMOVE NO. 1 CLEARANCE WARNING BUZZER
...
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR BUMPER ASSEMBLY
(See page )
2. REMOVE ULTRASONIC SENSOR CLIP
(a) Disconnect the connector.
Text in Illustration
*A
LH Side
*B
...