Toyota Venza: Cancellation of 4WD Control (C1299/99)

Toyota Venza Service Manual / Mf1a Transfer / 4wd / Awd / Active Torque Control 4wd System / Cancellation of 4WD Control (C1299/99)

DESCRIPTION

If wheel slip continues, differential control will be disabled when the torque-distribution ratio of the differential clutch exceeds the set value and a malfunction in the output of the wheel speed sensors, etc. occurs.
If a difference in diameter between the front and rear wheels is determined, differential control will be disabled.

DTC No.	DTC Detection Condition	Trouble Area
C1299/99	When one of the following conditions is met: - Condition that controls coupling calorific value is predefined value or more. - Vehicle is driven and energy load tire radius difference between front tires and rear tires is more than 3%.	Tire size AWD control ECU

CAUTION / NOTICE / HINT

HINT:

Check the condition of each related circuit connector before troubleshooting (See page ).

PROCEDURE

1.	CHECK TIRE CONDITION

(a) Check the size and condition of all 4 tires (See page ).

HINT:

This DTC is output when tire deformation or a difference in tire size is detected.

OK:

The diameter and air pressure of all 4 tires are the same.

REPLACE TIRE SO THAT ALL 4 TIRES ARE THE SAME IN SIZE

2.	RECONFIRM DTC

(a) Clear the DTC (See page ).

(b) Start the engine.

Result	Proceed to
DTC is output	A
DTC is not output	B

REPLACE AWD CONTROL ECU

CHECK INTERMITTENT PROBLEMS

Malfunction in Deceleration Sensor (C1245/93)

DESCRIPTION If a malfunction in the deceleration sensor circuit occurs, the AWD control ECU will output this DTC. DTC No. DTC Detecting Condition Trouble Area ...

ABS Malfunction (C1296/96)

DESCRIPTION If a malfunction in the speed sensor signal circuit occurs, the AWD control ECU will output this DTC. DTC No. DTC Detecting Condition Trouble Area ...

Other materials about Toyota Venza:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT COMPRESSOR FOR METALLIC SOUND (a) Check if there is abnormal metallic sound from the A/C compressor (compressor with pulley) when the A/C switch is on and the A/C compressor (compressor with pulley) operates. ...

All Door Entry Lock/Unlock Functions do not Operate, but Wireless Functions Operate
DESCRIPTION When the wireless door lock and unlock functions operate, the communication circuit between the door lock receiver assembly and certification ECU (smart key ECU assembly) is normal. When the entry lock and unlock functions do not operate, radi ...

Headlight Beam Level Control Actuator Circuit
DESCRIPTION The headlight leveling ECU assembly actuates the headlight leveling motor according to vehicle conditions. WIRING DIAGRAM PROCEDURE 1. READ VALUE USING TECHSTREAM (a) Connect the Techstream to the DLC3. (b) ...