Toyota Venza manuals

Toyota Venza: Brake System

Installation
INSTALLATION PROCEDURE 1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY (a) Install the brake pedal support assembly to the instrument panel reinforcement with the bolt. Torque: 19 N· ...

Precaution
PRECAUTION 1. TROUBLESHOOTING PRECAUTION NOTICE: Be sure to read the supplemental restraint system precautions thoroughly before servicing the brake system (See page ). Care mus ...

Other materials about Toyota Venza:

ABS Warning Light does not Come ON
DESCRIPTION The skid control ECU is connected to the combination meter via CAN communication. WIRING DIAGRAM Refer to ABS Warning Light Remains ON (See page ). PROCEDURE 1. CHECK CAN COMMUNICATION SYSTEM (a) Check if a C ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of ...

Test Mode Procedure
TEST MODE PROCEDURE 1. ENTER TEST MODE (SIGNAL CHECK MODE) (a) Turn the ignition switch off. (b) Connect the Techstream to the DLC3. (c) Turn the ignition switch to ON. (d) Check that the tire pressure warning light comes on for 3 seconds and then goes ...

© 2016-2026 Copyright www.tovenza.com

0.1466