Toyota Venza: Bottle holders

Toyota Venza Owners Manual / Interior features / Using the storage features / List of storage features / Bottle holders

► For front seats

► For rear seats

NOTICE
- Items that should not be stowed in the bottle holders

Put the cap on before stowing a bottle. Do not place open bottles in the bottle holders, or glasses and paper cups containing liquid. The contents may spill and glasses may break.

Cup holders

► Front ► Rear Pull down the armrest and open the lid. - Adjusting size of the front cup holder Remove the adapter. CAUTION - Items unsuitable for the cup holder D ...

Auxiliary boxes

►Type A (driver’s side instrument panel) Push down the knob. ►Type B (front console) Lift the lid. ►Type C (front console) Lift the lid. ►Type D (front passenger� ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. REMOVE REAR DOOR SCUFF PLATE RH HINT: Use the same procedure for the RH side and LH side (See page ). 2. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH HINT: Use the same procedure for the RH side and LH side (See page ). 3. ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" ...

Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0141,P102D)
DESCRIPTION Refer to DTC P0136 (See page ). HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is t ...