Toyota Venza manuals

Toyota Venza: Automatic transaxle


NOTICE
 - Automatic transaxle fluid type

Using transaxle fluid other than “Toyota Genuine ATF WS” may cause deterioration in shift quality, locking up of your transaxle accompanied by vibration, and ultimately damage the transaxle of your vehicle.

Transfer (AWD models)


Rear differential (AWD models)
...

Brakes
...

Other materials about Toyota Venza:

Input / Turbine Speed Sensor Circuit Malfunction (P0715,P0717)
DESCRIPTION This sensor detects the rotation speed of the turbine which shows the input revolution (speed) of the transaxle. By comparing the input turbine speed signal (NT) with the counter gear speed sensor signal (NC), the TCM detects the shift timing ...

Installation
INSTALLATION PROCEDURE 1. INSTALL FRONT BUMPER ASSEMBLY (a) Connect each connector. (b) Engage the 4 claws to install the front bumper assembly. HINT: Use the same procedure for the RH side and LH side. ...

Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0141,P102D)
DESCRIPTION Refer to DTC P0136 (See page ). HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is t ...

© 2016-2026 Copyright www.tovenza.com

0.1594