Toyota Venza: HD Radio Tuner Malfunction (B1551,B15A0,B15AD,B15B0,B15B3,B15B4,B15B7)

Toyota Venza Service Manual / Navigation / Multi Info Display / Navigation System / HD Radio Tuner Malfunction (B1551,B15A0,B15AD,B15B0,B15B3,B15B4,B15B7)

DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation receiver assembly.

DTC No.	DTC Detection Condition	Trouble Area
B1551	When any of the following conditions is met: "HD Radio" tuner decoder malfunction "HD Radio" tuner audio output section malfunction "HD Radio" tuner decoder RF/IF malfunction	Navigation receiver assembly
B15A0	When either of the following conditions is met: Bus malfunction EEPROM error
B15AD	When any of the following conditions is met: Short to ground or +B or open occurs in gyro signal circuit Gyro sensor malfunction GPS receiver malfunction
B15B0	Picture circuit (TFT unit) malfunction
B15B3	When any of the following conditions is met: AM tuner PLL is unlocked FM tuner PLL is unlocked Tuner malfunction
B15B4	When any of the following conditions is met: Mechanism drive signal malfunction Load/Eject malfunction Read mechanism malfunction Mechanical malfunction
B15B7	"Bluetooth" module malfunction

PROCEDURE

CHECK DTC

(a) Clear the DTCs (See page ).

(b) Recheck for DTCs and check that no DTCs are output.

OK:

No DTCs are output.

USE SIMULATION METHOD TO CHECK

REPLACE NAVIGATION RECEIVER ASSEMBLY

XM Tuner Antenna Disconnected (B15FE,B15FF)

DESCRIPTION These DTCs are stored when a malfunction occurs in the roof antenna assembly which is connected to the stereo component tuner assembly. DTC No. DTC Detection Cond ...

Satellite Radio Broadcast cannot be Received

CAUTION / NOTICE / HINT NOTICE: Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it will not be p ...

Other materials about Toyota Venza:

Check For Intermittent Problems
CHECK FOR INTERMITTENT PROBLEMS 1. CHECK FOR INTERMITTENT PROBLEMS HINT: A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected using the ECU Data List function of the Techstream. (a) ...

Power Seat does not Return to Memorized Position
DESCRIPTION When either the M1 or M2 switch is pressed, the outer mirror control ECU assembly LH sends a switch signal to the main body ECU (driver side junction block assembly) via CAN communication. Then, the main body ECU (driver side junction block as ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Lighting System DTC Code Detection Item See page B1244 Light Sensor Circuit Malfunction B124D Lost Communication with AFS LIN ...