Toyota Venza manuals

Toyota Venza: Variation Error (B2453)

DESCRIPTION

This DTC is stored if the headlight leveling ECU assembly for another destination is installed on the vehicle.

DTC No.

DTC Detecting Condition

Trouble Area

B2453

The headlight leveling ECU assembly for another destination is installed on the vehicle

Headlight leveling ECU assembly

PROCEDURE

1.

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY

(a) Replace the headlight leveling ECU assembly (See page ).



NEXT

2.

PERFORM INITIALIZATION

(a) Perform initialization of the headlight leveling ECU assembly (See page ).



NEXT

END

Height Control Sensor Data Out of Range When Initializing (B2452)
DESCRIPTION The headlight leveling ECU assembly stores this DTC if the sensor value received from the height control sensor is out of range when performing initialization of the headlight levelin ...

Light Sensor Circuit Malfunction (B1244)
DESCRIPTION The automatic light control sensor detects ambient light, converts it into an electrical signal, and outputs it to the main body ECU (driver side junction block assembly). The main bo ...

Other materials about Toyota Venza:

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing (See page ...

Customize Parameters
CUSTOMIZE PARAMETERS HINT: The following items can be customized. NOTICE: After confirming whether the items requested by the customer are applicable or not for customization, perform customizing operations. Be sure to record the current se ...

TC and CG Terminal Circuit
DESCRIPTION DTC output mode is set by connecting terminals TC and CG of the DLC3. DTCs are displayed by blinking of the SRS warning light. HINT: When each warning light stays blinking, a ground short in the wiring of terminal TC of the DLC3 or ...

© 2016-2026 Copyright www.tovenza.com

0.1687