Toyota Venza manuals

Toyota Venza: Registering ID codes

The tire pressure warning valve and transmitter is equipped with a unique ID code. When replacing a tire pressure warning valve and transmitter, it is necessary to register the ID code of tire pressure warning valve and transmitter. Have the ID code registered by your Toyota dealer.

 - When to replace your vehicle’s tires

Tires should be replaced if:

• You have tire damage such as cuts, splits, cracks deep enough to expose the fabric or bulges indicating internal damage • A tire goes flat repeatedly or cannot be properly repaired due to the size or location of a cut or other damage

If you are not sure, consult with your Toyota dealer.

 - Replacing tires and wheels

If the ID code of the tire pressure warning valve and transmitter is not registered, the tire pressure warning system will not work properly. After driving for about 20 minutes, the tire pressure warning light comes on after blinking for 1 minute to indicate a system malfunction.

 - Tire life

Any tire over 6 years old must be checked by a qualified technician even if they have seldom or never been used or damage is not obvious.

 - If the tread wears down below 0.16 in. (4 mm) on snow tires The effectiveness of snow tires is lost.

 - Maximum load of tire

Check that the number given by dividing the maximum load by 1.10 of the replacement tire is greater than 1/2 of the Gross Axle Weight Ratings (GAWR) of either the front axle or the rear axle, whichever is greater.


For the GAWR, see the Certification Label. For the maximum load of the tire, see the load limit at maximum cold tire inflation pressure mentioned on the sidewall of the tire.

 - Tire types

1 Summer tires
Summer tires are high-speed performance tires best suited to highway driving under dry conditions. Since summer tires do not have the same traction performance as snow tires, summer tires are inadequate for driving on snow-covered or icy roads. For driving on snow-covered roads or icy roads, the use of snow tires is recommended. When installing snow tires, be sure to replace all four tires.

2 All season tires
All season tires are designed to provide better traction in snow and to be adequate for driving in most winter conditions, as well as for use year round. All season tires, however, do not have adequate traction performance compared with snow tires in heavy or loose snow. Also, all season tires fall short in acceleration and handling performance compared with summer tires in highway driving.

3 Snow tires
For driving on snow-covered roads or icy roads, we recommend using snow tires. If you need snow tires, select tires of the same size, construction and load capacity as the originally installed tires. Since your vehicle has radial tires as original equipment, make sure your snow tires also have radial construction. Do not install studded tires without first checking local regulations for possible restriction. Snow tires should be installed on all wheels.

 - Routine tire inflation pressure checks

The tire pressure warning system does not replace routine tire inflation pressure checks. Make sure to check tire inflation pressure as part of your routine of daily vehicle checks.

 - Tire pressure warning system certification

For vehicles sold in the U.S.A.

FCC ID: PAXPMV107J
FCC ID: HYQ13BCX

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC WARNING

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

For vehicles sold in Canada Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

CAUTION

 - When inspecting or replacing tires

Observe the following precautions to prevent accidents. Failure to do so may cause damage to parts of the drive train, as well as dangerous handling characteristics, which may lead to an accident resulting in death or serious injury.

• Do not mix tires of different makes, models or tread patterns. Also, do not mix tires of remarkably different treadwear.

• Do not use tire sizes other than those recommended by Toyota.

• Do not mix differently constructed tires (radial, bias-belted, or bias-ply tires).

• Do not mix summer, all season and winter tires.

• Do not use tire that have been used on another vehicle.

Do not use tires if you do not know they were used previously.

• Do not tow the vehicle with the compact spare tire installed.

NOTICE
 - Repairing or replacing tires, wheels, tire pressure warning valves, transmitters and tire valve caps


• When removing or fitting the wheels, tires or the tire pressure warning valve and transmitter, contact your Toyota dealer as the tire pressure warning valve and transmitter may be damaged if not handled correctly.

• When replacing tire valve caps, do not use tire valve caps other than those specified. The cap may become stuck.

 - To avoid damage to the tire pressure warning valves and transmitters

When a tire is repaired with liquid sealants, the tire pressure warning valve and transmitter may not operate properly. If a liquid sealant is used, contact your Toyota dealer or other qualified service shop as soon as possible. Make sure to replace the tire pressure warning valve and transmitter when replacing the tire

- Driving on rough roads

Take particular care when driving on roads with loose surfaces or potholes.

These conditions may cause losses in tire inflation pressure, reducing the cushioning ability of the tires. In addition driving on rough roads may cause damage to the tires themselves, as well as the vehicle’s wheels and body.

 - If tire inflation pressures become low while driving

Do not continue driving, or your tires and/or wheels may be ruined.

Installing tire pressure warning valves and transmitters
When replacing tires or wheels, tire pressure warning valves and transmitters must also be installed. When new tire pressure warning valves and transmitters are installed, new tire pressure warni ...

Tire inflation pressure
 - Tire inflation pressure The recommended cold tire inflation pressure and tire size is displayed on the tire and loading information label.  - Inspection and adjustment procedure ...

Other materials about Toyota Venza:

Master Cylinder Pressure Sensor Malfunction (C1246/46,C1281/81)
DESCRIPTION Master cylinder pressure sensor is connected to the skid control ECU in the brake actuator assembly. DTC C1281/81 will be cleared when the master cylinder pressure sensor sends a master cylinder pressure signal or when Test Mode ends. DTC C12 ...

Steering Lock Position Signal Circuit Malfunction (B2285)
DESCRIPTION This DTC is stored when serial communication signals and LIN communication signals in the circuit between the power management control ECU and steering lock actuator assembly (steering lock ECU) are inconsistent. DTC No. ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Sliding Roof / Trouble Codes. (e) Check the details of the DTC(s) (See ...

© 2016-2019 Copyright www.tovenza.com

0.0069