Toyota Venza: Problem Symptoms Table

HINT:

• Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
• Inspect the fuses and relays related to this system before inspecting the suspected areas below.

Initialization

INITIALIZATION 1. INITIALIZE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) NOTICE: When the sliding roof glass, sliding roof housing or sliding roof ECU (sliding roof drive ge ...

Diagnosis System

DIAGNOSIS SYSTEM 1. DESCRIPTION (a) Sliding roof system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3). When the system seems to be malfuncti ...

Other materials about Toyota Venza:

Power Mirrors do not Return to Memorized Position
SYSTEM DESCRIPTION If either the M1 or M2 seat memory switch is pressed, the outer mirror control ECU assembly (driver door) detects the seat memory switch status and sends the switch signal to the main body ECU (driver side junction block assembly) via C ...

Lost Communication with Gateway Module (MS Bus) (U1002)
DESCRIPTION The main body ECU will store this DTC when no signals can be received from the ECUs that have been memorized as those that are connected to the CAN MS bus. When the main body ECU receives a response signal from the ECUs connecte ...

Bank 1 Air-Fuel Ratio Imbalance (P219A,P219C-P219F)
DESCRIPTION Refer to DTC P0300 (See page ). Refer to DTC P2195 (See page ). DTC No. DTC Detection Condition Trouble Area P219A The difference in air fuel ratios between the cylinders exceeds the ...