Toyota Venza: Precaution
PRECAUTION
1. NOTICE FOR INITIALIZATION:
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
|
System Name |
See Procedure |
|---|---|
|
Back Door Closer System |
|
|
Power Back Door System |
.gif)
2. PRECAUTIONS WHEN WORKING ON STEERING LOCK SYSTEM
(a) After replacing the steering lock ECU (steering lock actuator assembly), perform the key ID code registration.
(b) After replacing the steering lock ECU (steering lock actuator assembly), confirm the lock/unlock operation of the steering lock.
Operation Confirmation|
Steering Lock Condition |
Operation Condition |
|---|---|
|
Lock |
With the ignition switch off, open and close any door. |
|
Unlock |
Turn the ignition switch from off to ON or ACC. |
Parts Location
PARTS LOCATION
ILLUSTRATION
...
Other materials about Toyota Venza:
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
If the sensor rotor needs to be replaced, replace it together with the
rear drive shaft assembly.
...
Fail-safe Chart
FAIL-SAFE CHART
Engine Coolant Temperature Gauge
Condition
Response
Recovery
Engine coolant temperature data is interrupted for 3 seconds.
The gauge needle indicates below C.
Engine cool ...
ECU Power Source Circuit
DESCRIPTION
This circuit provides power to operate the transponder key ECU assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
If the transponder key ECU assembly is replaced, register the key and ECU communication
ID (See page ).
PROCEDURE
...
0.1697