Toyota Venza manuals

Toyota Venza: Dtc Check / Clear

DTC CHECK / CLEAR

1. CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes.

(e) Check for DTCs (See page ).


NOTICE:

The navigation receiver assembly*1 or radio and display receiver assembly*2 outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the rear view monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant systems.

System

Proceed to

Navigation System*1


Audio and Visual System*2


  • *1: for Navigation System
  • *2: for Audio and Visual System

2. CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes.

(e) Clear the DTCs.

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Rear View Monitor System DTC Code Detection Item See page C1622 Back Camera Disconnected ...

Back Camera Disconnected (C1622)
DESCRIPTION This DTC is stored if the navigation receiver assembly*1 or radio and display receiver assembly*2 judges that the signals or signal lines between the navigation receiver assembly*1 or ...

Other materials about Toyota Venza:

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) Front power seat control system (w/ Memory) data and Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream t ...

Transmitter ID1 Error (C2141/41-C2144/44)
DESCRIPTION The tire pressure warning valve and transmitter installed in each tire and wheel assembly measures the tire pressures. The measured values are transmitted as radio waves to the tire pressure warning antenna and receiver on the body and then se ...

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY) (a) Disconnect the 2A, 2C and 2F main body ECU (driver side junction block assembly) connectors. (b) Measure the voltage and resistance according to the value(s) in the table ...

© 2016-2026 Copyright www.tovenza.com

0.1149