Toyota Venza: Diagnostic Trouble Code Chart

Toyota Venza Service Manual / Lighting (ext) / Lighting System / Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART

Lighting System

DTC Code	Detection Item	See page
B1244	Light Sensor Circuit Malfunction
B124D	Lost Communication with AFS LIN
B124A	Automatic High Beam Mirror
B124B	Automatic High Beam System
B124C	Automatic High Beam Camera
B2414	Steering Position Sensor Malfunction
B2415	Vehicle Speed Sensor Malfunction
B2416	Height Control Sensor Malfunction
B241A	Rear Height Control Sensor
B2420	HL AutoLeveling ECU Failure
B2432	Lost Communication with Automatic High Beam Sensor
B2450	Initialization has not been Performed
B2451	Vehicle Specifications have not been Stored
B2452	Height Control Sensor Data Out of Range When Initializing
B2453	Variation Error
U0073	Control Module Communication Bus Off
U0101	Lost Communication with ECM
U0126	Lost Communication with Steering Angle Sensor Module
U0129	Lost Communication with Skid Control ECU
U0142	Lost Communication with Main Body ECU
U0182	Lost Communication with AFS ECU
U1000	Can Communication Failure(Message Registry)

Data List / Active Test

DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuator and other items to be read without removing any pa ...

Vehicle Specifications have not been Stored (B2451)

DESCRIPTION The headlight leveling ECU assembly stores this DTC if the vehicle specifications have not been stored in the ECU. HINT: The vehicle specifications are stored in the ECU at the factor ...

Other materials about Toyota Venza:

Inspection
INSPECTION PROCEDURE 1. INSPECT LUMBAR SUPPORT ADJUSTER ASSEMBLY (a) Check operation of the lumbar support adjuster. (1) Check if the lumbar support adjuster moves smoothly when the battery is connected to the lumbar support adjuster motor connector te ...

Transmission Fluid Temperature Sensor "A" Performance (P0711)
DESCRIPTION The Automatic Transmission Fluid (ATF) temperature sensor converts the fluid temperature into a resistance value for use by the TCM. The TCM applies a voltage to the temperature sensor through terminal THO1 of the TCM. The sensor resistance ...

Checking Monitor Status
CHECKING MONITOR STATUS The purpose of the monitor result (mode 06) is to allow access to the results of on-board diagnostic monitoring tests of specific components/systems that are not continuously monitored. Examples are catalysts and evaporative emissi ...