Toyota Venza manuals

Toyota Venza: Diagnosis System

DIAGNOSIS SYSTEM

1. DESCRIPTION

The ECU stores trouble codes when trouble occurs on the vehicle.

The diagnostic system allows for reading of the trouble codes from the DLC3.

Use the Techstream to check and solve the problem.

2. CHECK DLC3

(a) Check the DLC3 (See page ).


Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY) (a) Disconnect the main body ECU (driver side junction block assembly) connectors. (b) Measure the resistance and vol ...

Other materials about Toyota Venza:

SRS Warning Light Remains ON
DESCRIPTION The SRS warning light is located on the combination meter assembly. When the SRS is normal, the SRS warning light comes on for approximately 6 seconds after the ignition switch is turned from off to ON, and then goes off automatically. If ther ...

Installation
INSTALLATION PROCEDURE 1. CLEAN FRONT SIDE FIX WINDOW ASSEMBLY (a) Clean the outer edges of the front side fix window assembly with a non-residue solvent. NOTICE: Do not touch the glass surface after cleaning it. Be c ...

Removal
REMOVAL PROCEDURE 1. DRAIN AUTOMATIC TRANSAXLE FLUID 2. REMOVE FRONT FRAME ASSEMBLY See page 3. SUPPORT ENGINE ASSEMBLY 4. REMOVE BELT 5. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY (a) Remove the 18 bolts and automatic transa ...

© 2016-2026 Copyright www.tovenza.com

0.117