Toyota Venza: Diagnosis System

Toyota Venza Service Manual / Seat / Front Power Seat Control System(w/ Memory) / Diagnosis System

DIAGNOSIS SYSTEM

1. DESCRIPTION

(a) Front power seat control system (w/ Memory) data and Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs.

2. CHECK DLC3

(a) Check the DLC3 (See page ).

3. INSPECT BATTERY VOLTAGE

(a) Check the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery.

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Terminals Of Ecu

TERMINALS OF ECU 1. CHECK POSITION CONTROL ECU AND SWITCH ASSEMBLY (a) Disconnect the T10 and T11 position control ECU and switch assembly connectors. (b) Measure the voltage and resistance accor ...

Other materials about Toyota Venza:

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE REAR WHEEL 2. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY (a) Remov ...

System Diagram
SYSTEM DIAGRAM 1. CAN AND DIRECT LINE SIGNALS 2. INPUT AND OUTPUT SIGNALS OF THE ACCESSORY METER ASSEMBLY Warning light or indicator light Communication Signal Receiver Communication Line Sender ...

Checking Monitor Status
CHECKING MONITOR STATUS The purpose of the monitor result (mode 06) is to allow access to the results of on-board diagnostic monitoring tests of specific components/systems that are not continuously monitored. Examples are catalysts and evaporative emissi ...