Toyota Venza manuals

Toyota Venza: Diagnosis System

DIAGNOSIS SYSTEM

1. CHECK DLC3

(a) Check the DLC3 (See page ).


2. FUNCTION OF P/S WARNING LIGHT

(a) When a malfunction is detected in the power steering system, the P/S warning light on the accessory meter comes on to inform the driver of the malfunction.


HINT:

When power assist is stopped or reduced, the P/S warning light comes on.

Power assist is stopped:

  • When a malfunction occurs in the power steering system (including lost CAN communication etc.)
  • When the engine stalls (not a malfunction)
  • During the period after the ignition switch is turned to ON until the engine is started (not a malfunction)

Power assist is reduced:

  • When a malfunction occurs in the power steering system (including lost CAN communication etc.)
  • When the battery voltage decreases (not a malfunction)

3. CHECK P/S WARNING LIGHT

(a) Check that the P/S warning light comes on when the ignition switch is turned to ON and goes off in approximately 3 seconds.

(b) If the warning light remains on, refer to PS Warning Light Remains ON (See page ).


Terminals Of Ecu
TERMINALS OF ECU 1. CHECK POWER STEERING ECU HINT: As connector z8 uses a lock lever, each terminal cannot be checked while the connector is still connected to the power steering ECU. ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Turn the ignition switch off. (b) Connect the Techstream to the DLC3. (c) Turn the ignition switch to ON. (d) Turn the Techstream on. (e) Read the DTCs followi ...

Other materials about Toyota Venza:

Inspection
INSPECTION PROCEDURE 1. INSPECT REAR SPEAKER ASSEMBLY (a) With the speaker installed, check that there is no looseness or other abnormalities. (b) Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities. ...

PIG Power Supply Voltage Malfunction (C1552)
DESCRIPTION When a problem occurs in the power steering system, the power source relay circuit is shut off to stop the power assist. DTC No. DTC Detection Condition Trouble Area C1552 PIG power s ...

Radio Receiver Power Source Circuit
DESCRIPTION This is the power source circuit to operate the radio and display receiver assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following inspection procedure. ...

© 2016-2026 Copyright www.tovenza.com

0.1857