Toyota Venza: Customize Parameters
CUSTOMIZE PARAMETERS
HINT:
The following items can be customized.
NOTICE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make a note of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
1. CUSTOMIZE
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menu: Body Electrical / Main Body or Illuminated Entry / Utility / Customize.
(e) Select the setting by referring to the table below.
Wireless Door Lock Control System|
Display (item) |
Default |
Function |
Setting |
|---|---|---|---|
|
Wireless Control |
ON |
Function that turns wireless door lock function ON/OFF |
ON or OFF |
|
Hazard Answer Back |
ON |
When the doors are locked by wireless operation, the hazard warning lights flash once. When the doors are unlocked by wireless operation, the hazard warning lights flash twice. |
ON or OFF |
|
Open Door Warning |
ON |
The buzzer sounds when LOCK is pressed when any of the doors are ajar. |
ON or OFF |
|
Unlock 2 Operation |
ON |
Function that unlocks driver side door when unlock switch on transmitter is pressed once, and unlocks all doors when pressed twice. If setting is OFF, pressing unlock switch once makes all doors unlock. |
ON or OFF |
|
Panic Function |
ON |
Function to operate theft deterrent system by continuously pressing panic switch on transmitter for 0.8 seconds |
ON or OFF |
|
Auto Lock Time |
60 s |
This function regulates the interval between unlocking and automatic relocking of doors. |
30 s, 60 s or 120 s |
|
Wireless Auto Lock |
ON |
This function turns the wireless auto lock function on or off. |
ON or OFF |
|
Wireless Buzzer Resp |
ON |
Wireless door lock buzzer response / ON or OFF |
ON or OFF |
|
Wireless Buzzer Vol |
Level7 |
Wireless door lock buzzer Volume |
Level7, Level6, Level5, Level4, Level3, Level2, Level1 or Level0 |
Operation Check
OPERATION CHECK
1. NOTICE WHEN CHECKING THE FOLLOWING
(a) Power door lock/unlock function:
This wireless door lock control function operates only when the following 3 conditions
are met:
(1) The ...
Registration
REGISTRATION
CAUTION / NOTICE / HINT
HINT:
Register a new recognition code when replacing the door control transmitter
or the door control receiver.
Add mode is used to retain the a ...
Other materials about Toyota Venza:
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. CONNECT TECHSTREAM
(a) Connect the Techstream to the DLC3.
(b) Start the engine and run it at idle.
(c) Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
HINT:
Refer to the Techstream operator's manu ...
Transmission Range Sensor Circuit Malfunction (PRNDL Input) (P0705)
DESCRIPTION
The park/neutral position switch detects the shift lever position and sends signals
to the TCM.
DTC No.
DTC Detection Condition
Trouble Area
P0705
(A) Any 2 or more signals of the fol ...
Driver Side Door Entry Lock Function does not Operate
DESCRIPTION
If the driver door entry unlock function operates normally, but its entry lock
function does not, this means that the request code from the driver door is being
output normally. In this case, a malfunction in the lock sensor circuit (from the ...
0.1321