Toyota Venza: Assist grips (folding type)

Toyota Venza Owners Manual / Interior features / Other interior features / Assist grips (folding type)

An assist grip installed on the ceiling can be used to support your body while sitting on the seat.

CAUTION

- Assist grip

Do not use the assist grip when getting in or out of the vehicle or rising from your seat.

NOTICE
- To prevent damage to the assist grip

Do not hang any heavy object or put a heavy load on the assist grip.

Armrest

►Front Lift the lever up and slide the armrest. ► Rear Pull the armrest down for use. NOTICE - To prevent damage to the armrest Do not place too much strain on the armrest. ...

Floor mats

Use only floor mats designed specifically for vehicles of the same model and model year as your vehicle. Fix them securely in place onto the carpet. Insert the retaining hooks (clips) into the fl ...

Other materials about Toyota Venza:

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT SIDE MARKER LIGHT BULB (a) Install the front side marker light bulb to the front side marker light socket. (b) Turn the front side marker light socket with the front side marker light bulb in the directi ...

Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0141,P102D)
DESCRIPTION Refer to DTC P0136 (See page ). HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is t ...

Sensor (Motor) Failure (B2341,B2344)
DESCRIPTION When the sliding roof ECU (sliding roof drive gear sub-assembly) detects a motor malfunction and the sliding roof operation is stopped, DTC B2341 is output. When the sliding roof ECU (sliding roof drive gear sub-assembly) detects a gear malfu ...