DESCRIPTION
Detection Item |
Symptom |
Trouble Area |
---|---|---|
Yaw Rate Sensor Communication Stop Mode |
|
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
HINT:
PROCEDURE
1. |
CHECK CAN BUS WIRE FOR DISCONNECTION (YAW RATE AND ACCELERATION SENSOR BRANCH WIRE) |
(a) Turn the ignition switch off.
(b) Disconnect the connector of the yaw rate and acceleration sensor. Text in Illustration
|
|
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
D30-2 (CANH) - D30-3 (CANL) |
Ignition switch off |
54 to 69 Ω |
NG |
REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (YAW RATE AND ACCELERATION SENSOR BRANCH WIRE) |
|
2. |
CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL) |
(a) Turn the ignition switch to ON. |
|
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
D30-1 (IGA) - Body ground |
Ignition switch ON |
11 to 14 V |
*1 |
Front view of wire harness connector (to Yaw Rate Sensor) |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT) |
|
3. |
CHECK HARNESS AND CONNECTOR (GROUND TERMINAL) |
(a) Turn the ignition switch off. |
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
D30-4 (GNDA) - Body ground |
Always |
Below 1 Ω |
*1 |
Front view of wire harness connector (to Yaw Rate Sensor) |
OK |
REPLACE YAW RATE SENSOR |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT) |
Inspection
INSPECTION
PROCEDURE
1. INSPECT CHARCOAL CANISTER ASSEMBLY
(a) Visually check the charcoal canister assembly.
(1) Visually check the charcoal canister assembly for cracks or damage.
If cracks or damage are found, replace the charcoal canister ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL TRANSFER ASSEMBLY
(a) Install the transfer assembly to the transaxle assembly with 2 new
bolts and the 6 nuts.
Torque:
69 N·m {700 kgf·cm, 51 ft·lbf}
NOTICE:
Install the transfer ...
Intake Manifold Runner Control Circuit Low (Bank 1) (P2009,P2010)
DESCRIPTION
The ECM activates the DC motor for the tumble control valve, which opens and
closes the tumble control valve. The ECM activates the DC motor based on engine
speed, coolant temperature, intake air temperature and other conditions.
D ...