Toyota Venza manuals

Toyota Venza: When closing the back door


Lower the back door using the back door handle, and make sure to push the back door down from the outside to close it.

Be careful not to pull the back door sideways when closing the back door with the handle.

Back door
The back door can be opened using the back door opener. The back door can be locked and unlocked using the entry function (vehicles with smart key system), wireless remote control or door lock swi ...

Power back door switch (vehicles with power back door)
Push the switch to close. Pressing the switch again while the power back door is closing will cause it to open again. However, the reverse operation cannot be performed for the first second afte ...

Other materials about Toyota Venza:

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT BLOWER MOTOR SUB-ASSEMBLY (a) Install the front blower motor sub-assembly with the 3 screws. 2. INSTALL AIR INLET SERVO MOTOR SUB-ASSEMBLY (a) Insta ...

Noise Occurs from Generator while Engine is Running
PROCEDURE 1. CHECK LOOSENESS OF V-RIBBED BELT (a) Check the tension of the belt by pushing it down with a finger. OK: The tension of the belt is enough. NG ADJUST V-RIBBED BELT ...

Short to GND in Immobiliser System Power Source Circuit (B278A)
DESCRIPTION This DTC is stored when the engine switch power source supply line is open or shorted. DTC No. DTC Detection Condition Trouble Area B278A Engine switch power source supply line is ope ...

© 2016-2026 Copyright www.tovenza.com

0.1537