Components
COMPONENTS
ILLUSTRATION
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT REAR WASHER NOZZLE
(a) With the engine running, check where the washer fluid hits the windshield.
Standard Measurement
Area |
Dimension |
Area |
Dimension |
---|---|---|---|
A |
134.4 mm (5.29 in.) |
B |
63.5 mm (2.50 in.) |
C |
75.4 mm (2.97 in.) |
D |
28.2 mm (1.11 in.) |
E |
38.1 mm (1.50 in.) |
F |
120 mm (4.72 in.) |
G |
38.7 mm (1.52 in.) |
H |
180.1 mm (7.09 in.) |
*1 |
Minimum Spray |
*2 |
Maximum Spray |
*3 |
Nominal Spray |
- |
- |
OK:
Washer fluid hits the windshield in the area shown in the illustration.
Adjustment
ADJUSTMENT
PROCEDURE
1. ADJUST REAR WASHER NOZZLE
(a) Using a screwdriver, adjust the direction of the rear washer nozzle. NOTICE: Do not use a safety pin or other pointed tools. Doing so may damage the inside of the washer nozzle. HINT: Use a thin-bladed screwdriver with an approximately 1 mm (0.0394 in.) thick tip. |
|
Removal
REMOVAL
PROCEDURE
1. REMOVE UPPER BACK WINDOW PANEL TRIM
2. REMOVE REAR SPOILER ASSEMBLY
3. REMOVE REAR WASHER NOZZLE
(a) Disconnect the washer hose. |
|
(b) Disengage the 2 claws and remove the rear washer nozzle.
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR WASHER NOZZLE
(a) Engage the 2 claws to install the rear washer nozzle. |
|
(b) Connect the washer hose.
2. INSPECT REAR WASHER NOZZLE
3. ADJUST REAR WASHER NOZZLE
4. INSTALL REAR SPOILER ASSEMBLY
5. INSTALL UPPER BACK WINDOW PANEL TRIM
Switch Failure (B2342)
DESCRIPTION
This DTC is output when the sliding roof ECU (sliding roof drive gear sub-assembly)
detects that the sliding roof switch is stuck for 30 seconds or more.
DTC Code
DTC Detection Condition
Trouble Area
...
Dtc Check / Clear
DTC CHECK / CLEAR
1. DTC CHECK/CLEAR (When Using the Techstream)
(a) Check for DTCs.
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream on.
(4) Read the DTCs following the prompts on the Techstream. Enter ...
Front Passenger Side Power Window Auto Up / Down Function does not Operate with
Front Passenger Side Power Window Switch
DESCRIPTION
If the manual up/down function can be performed but the auto up/down function
cannot, the fail-safe mode may be functioning.
If the power window initialization (See page
) has not been performed, the auto up/down function
will not operate.
...