Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT LEVEL WARNING SWITCH ASSEMBLY
HINT:
The following check should be performed with the windshield washer motor and pump installed to the washer jar.
(a) Fill the washer jar with washer fluid.
(b) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the level warning switch assembly. Text in Illustration
|
|
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL RH
2. REMOVE FRONT FENDER OUTSIDE MOULDING RH
HINT:
Use the same procedure for the RH side and LH side (See page ).
3. REMOVE FRONT FENDER LINER RH
4. DRAIN WINDSHIELD WASHER FLUID
5. REMOVE WASHER LEVEL WARNING SWITCH ASSEMBLY
(a) Disconnect the connector. |
|
(b) Remove the washer level warning switch assembly.
Installation
INSTALLATION
PROCEDURE
1. INSTALL WASHER LEVEL WARNING SWITCH ASSEMBLY
(a) Install the washer level warning switch assembly. |
|
(b) Connect the connector.
(c) Connect the washer hose. |
|
2. FILL WASHER JAR WITH WASHER FLUID
3. INSTALL FRONT FENDER LINER RH
4. INSTALL FRONT FENDER OUTSIDE MOULDING RH
HINT:
Use the same procedure for the RH side and LH side (See page ).
5. INSTALL FRONT WHEEL RH
Compressor Solenoid Circuit (B1451/51)
DESCRIPTION
In this circuit, the A/C compressor receives a refrigerant compression demand
signal from the A/C amplifier.
Based on this signal, the A/C compressor changes the amount of compressor output.
DTC No.
DTC Detection Conditio ...
Open in Rear Floor Electrical Key Oscillator Circuit (B27A6)
DESCRIPTION
The certification ECU (smart key ECU assembly) generates a request signal and
sends it to the indoor electrical key oscillator (for center floor). To detect the
key inside the cabin, the indoor electrical key oscillator (for center floor) crea ...
Lost Communication with A/C ECU (U0164)
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
U0164
No communication from the air conditioning amplifier continues.
Air conditioning amplifier branch wire or connect ...