Toyota Venza: Vehicle Speed Sensor "A" Intermittent / Erratic / High (P0503)

Toyota Venza Service Manual / Cruise Control / Cruise Control System / Vehicle Speed Sensor "A" Intermittent / Erratic / High (P0503)

DESCRIPTION

If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the skid control ECU is detected while the cruise control is in operation, the ECM determines that there is a momentary interruption or noise, and outputs a DTC.

DTC	DTC Detection Condition	Trouble Area
P0503	A momentary interruption and noise are detected when a rapid change of the vehicle speed occurs while cruise control is in operation.	Vehicle speed sensors Vehicle speed sensor signal circuit Combination meter assembly ECM

WIRING DIAGRAM

CAUTION / NOTICE / HINT

This DTC may be output by the vehicle stability control system at the same time. In that case, perform troubleshooting for the vehicle stability control system first.

PROCEDURE

1.	CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: Chassis / ABS/VSC/TRC / DTC.

(e) Check for DTCs.

Result	Proceed to
DTC is not output	A
DTC is output	B

GO TO VEHICLE STABILITY CONTROL SYSTEM (DTC CHART)

2.	REPLACE COMBINATION METER ASSEMBLY

(a) Replace the combination meter assembly (See page ).

3.	CHECK DTC (CRUISE CONTROL SYSTEM)

(a) Clear the DTCs (See page ).

(b) Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.

(1) Drive at the required speed of between 40 km/h (25 mph) and 200 km/h (125 mph).

(2) Turn the cruise control main switch on.

(3) Push the -SET switch to activate the cruise control.

Result	Proceed to
DTC is not output	A
DTC P0503 is output (for 1AR-FE)	B
DTC P0503 is output (for 2GR-FE)	C

END

REPLACE ECM

Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART If a trouble code is displayed during the DTC check, check the trouble areas listed for that code in the table below and proceed to the appropriate page. Cruise Contr ...

Vehicle Speed Sensor Malfunction (P0500)

DESCRIPTION The vehicle speed sensors detect the wheel speed and send the appropriate signals to the skid control ECU. The skid control ECU converts these wheel speed signals into a 4-pulse signa ...

Other materials about Toyota Venza:

Power Mirror cannot be Adjusted with Power Mirror Switch
SYSTEM DESCRIPTION The main body ECU (driver side junction block assembly) detects the mirror adjust switch status and sends the signal to the outer mirror control ECU assembly via CAN communication. On receiving the signal, each outer mirror control ECU ...

Fail-safe Chart
FAIL-SAFE CHART 1. Fail-safe This function minimizes the loss of operation when any abnormality occurs in a sensor or solenoid. Fail-safe Control List Malfunction Part Function Input Turbine Speed Sensor ...

Removal
REMOVAL PROCEDURE 1. REMOVE FRONT SEAT HEADREST ASSEMBLY 2. REMOVE FRONT SEAT REAR OUTER TRACK COVER 3. REMOVE FRONT SEAT REAR INNER TRACK COVER 4. REMOVE FRONT SEAT ASSEMBLY 5. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB 6. REMOVE RECL ...