DESCRIPTION
The tire pressure warning ECU receives a vehicle speed signal from the combination meter and an engine speed signal from the ECM. The tire pressure warning ECU uses these signals to detect DTCs C2121/21 to C2124/24 (No Signal from Transmitter).
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
C2173/73 |
When either of the following conditions is met for a total of 15 minutes: (a) No engine speed signal while vehicle speed is 8 km/h (5 mph) or more (b) No vehicle speed signal while engine speed is a specified value |
|
HINT:
This DTC is set at the same time as DTCs C2121/21 to C2124/24 are being set.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
PROCEDURE
1. |
PERFORM SIGNAL CHECK (VEHICLE SPEED SIGNAL AND ENGINE SPEED SIGNAL) |
(a) Enter the signal check mode in Test Mode Procedure (See page ).
(b) Drive the vehicle at 20 km/h (12 mph) or more for 10 seconds to clear DTC C2191/91.
(c) Start the engine and allow it to run at 1000 rpm for 3 seconds or more to clear DTC C2194/94.
(d) Check for signal check DTCs.
Result |
Proceed to |
---|---|
DTCs C2191/91 and C2194/94 are cleared |
A |
DTC C2191/91 is output |
B |
DTC C2194/94 is output |
C |
HINT:
DTCs C2181/81 to C2184/84 (Transmitter ID not Received) are output at this time, but they are not related to this check.
A |
USE SIMULATION METHOD TO CHECK |
B |
GO TO DTC C2191/91 |
C |
GO TO DTC C2194/94 |
Inspection
INSPECTION
PROCEDURE
1. INSPECT SHIFT SOLENOID VALVE SL
(a) Measure the resistance according to the value(s) in the table below.
Text in Illustration
*1
Shift Solenoid Valve SL
Standard Re ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT SEAT ASSEMBLY
(a) Place the front seat assembly in the cabin.
NOTICE:
Be careful not to damage the vehicle body.
(b) Connect each connector under the front seat assembly.
(c) Temporarily install the front seat ass ...
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR SEAT HEADREST ASSEMBLY
2. REMOVE REAR SEAT INNER TRACK BRACKET COVER
3. REMOVE REAR SEAT OUTER TRACK BRACKET COVER
4. DISCONNECT REAR SEAT NO. 2 RECLINING CONTROL CABLE SUB-ASSEMBLY
5. REMOVE REAR SEAT ASSEMBL ...