Toyota Venza: Using the automatic mode

Toyota Venza Owners Manual / Interior features / Using the air conditioning system and defogger / Automatic air conditioning system / Using the automatic mode

Press
.

The air conditioning system will begin to operate. In outside air or recirculated air mode, air outlets, fan speed and air conditioning on/ off are automatically adjusted according to the temperature setting.

“AUTO” will be displayed on the multi-information display, along with the temperature setting. The settings that are automatically adjusted by the system are not displayed. When only “AUTO” and the temperature settings are displayed, may be pressed a second time to temporarily
display all system settings.

Turn the temperature control dial
clockwise (warm) or counterclockwise (cool).

The temperature for the driver’s and front passenger’s seats can be set separately.

Turn the temperature control dial clockwise (warm) or counterclockwise (cool).

The temperature for the driver’s and front passenger’s seats can be set separately.

Automatic air conditioning system

Airflow and outlets are automatically adjusted according to the temperature setting. ► Control panel ► Multi-information display (TFT type) The settings display will differ ...

Adjusting the settings

- Adjusting the temperature setting Turn the temperature control dial clockwise (warm) or counterclockwise (cool). The air conditioning system switches between dual and simultaneous modes each ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. NOTICE: When disconnecting the cable, some systems ne ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column ...

Lost Communication with TCM (U0101)
DESCRIPTION The Transmission Control Module (TCM) and ECM perform 2-way communication with each other via the Controller Area Network (CAN). The TCM sends signals to the ECM concerning required engine speed, required engine torque, warning indicators in ...