DESCRIPTION
This DTC is stored when a malfunction occurs in a connected device.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B1585 |
When any of the following conditions is met:
|
|
PROCEDURE
1. |
REPLACE USB DEVICE OR "iPod" |
(a) Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
(b) Turn the ignition switch off.
HINT:
When this DTC has been stored, it is necessary to turn the ignition switch off make it possible for the vehicle to recognize a new device when it is connected.
(c) Turn the ignition switch to ACC.
(d) Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
HINT:
|
2. |
CHECK DTC |
(a) Clear the DTCs (See page ).
(b) Recheck for DTCs and check that no DTCs are output.
OK:
No DTCs are output.
OK |
USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USBDEVICE OR "iPod" WAS DEFECTIVE |
NG |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
Transmission Wire(when Not Using The Engine Support Bridge)
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL TRANSMISSION WIRE
(a) Coat the O-ring with ATF.
(b) Coat the bolt with ATF.
(c) Install the tr ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
If the sensor rotor needs to be replaced, replace it together with the
front drive shaft assembly.
...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
(a) Disconnect the main body ECU (driver side junction block assembly) connectors.
(b) Measure the resistance and voltage according to the value(s) in the table
below.
...